Blodgett SG3240E Installation Operation & Maintenance page 39

Conveyor ovens
Hide thumbs Also See for SG3240E:
Table of Contents

Advertisement

Available languages

Available languages

POSSIBLE CAUSE(S)
SYMPTOM: Burner will not fire (SG3240G) or elements will not heat (SG3240E).
Control turned off.
S
Temperature set point not above the ambient
S
temperature.
Convection blower motor(s) not running.
S
Display: BLOWER FAULT --- CALL SERVICE
Fuse(s) are blown.
S
Emergency stop button is pushed in.
S
For SG3240G ovens only
Manual gas valve closed.
S
Combustion blower motor not running.
S
Display: COMBUSTION BLWR FAIL --- CALL
SERVICE
Combustion blower pressure switch defective or
S
not set properly.
Display: COMB PS FAULT --- CALL SERVICE
Burner did not ignite properly or flame ceased.
S
Display: IGNITION ALARM --- PRESS RESET
or NO FLAME SENSE --- RESET OR CALL SERVICE
SYMPTOM: Oven will not reach desired temperature.
Manifold gas pressure to too low (SG3240G).
S
Gas pressure to oven is too low (SG3240G).
S
Convection blower motor(s) not running.
S
Fuse(s) are blown.
S
Emergency stop button is pushed in.
S
Defective heating element relay (SG3240E).
S
Heating element(s) burned out (SG3240E).
S
Temperature hi-limit switch tripped (open) or out
S
of adjustment or defective.
Display: HI LIMIT TRIP --- RESET EGO
Internal problem with control.
S
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
Maintenance
SUGGESTED REMEDY
Press ON/OFF key.
S
Set to the desired temperature. See page 27 of
S
the Operation section for instructions.
*
S
Unplug the oven power cord and check the fuses
S
(SG3240E). Call service if necessary.
Pull the button out to disengage the emergency
S
stop.
Open valve.
S
*
S
*
S
Press the reset button on the electrical box
S
control tray, located to the left of the LED
indicator lights. Call service if necessary.
*
S
Contact local gas representative.
S
*
S
Unplug the oven power cord and check the fuses
S
(SG3240E). Call service if necessary.
Pull the button out to disengage the emergency
S
stop.
*
S
*
S
Press red EGO reset button on rear of electrical
S
box. Call service if necessary.
*
S
35
Troubleshooting Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sg3240g

Table of Contents