Standard Conveyor Assembly - Blodgett SG3240E Installation Operation & Maintenance

STANDARD CONVEYOR ASSEMBLY

Conveyor Racks
1. Slide the drive side conveyor support rack
onto the conveyor support angles.
NOTE: The sprocket on the conveyor rack must
be inside the electrical box after being
pushed into the oven. See View A.
2. Install the drive chain around the drive motor
sprocket and the sprocket on the conveyor
rack. Pull the conveyor rack forward to tighten
the chain.
See View A
Drive Side
Conveyor Rack
3. Secure the conveyor using the conveyor locat-
ing pin. See View A.
4. Slide the idle side conveyor rack onto the con-
veyor support angles until it touches the drive
side conveyor rack.
NOTE: If the mounting hole cannot be lined up or
the chain is too loose, the drive motor will
need to be repositioned.
Sprocket
See View A
Locating
Pin
Figure 9
13
Installation
Oven Assembly
View A
Conveyor
Bracket
Idle Side
Conveyor Rack