Replacing The Filter; Removing The Filter; Technical Data - DeLonghi PrimaDonna S Evo ECAM51 55 Series Instructions For Use Manual

5. Insert the filter in the water tank and immerse it completely
for about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape (fig. 38);
6. Insert the filter in the filter housing (A19) and press as far
as it will go (fig. 39);
7. Close the tank with the lid (A17 - fig. 40), then replace the
tank in the machine;
39
When you install the filter, you must notify the appliance of its
presence.
8. Press (B2) to enter the "Settings" menu;
9. Press the selection arrows (B4 and B5) until "Maintenance"
is displayed between the two dotted lines: press
(B3);
10. Press the selection arrows until "Install filter" is displayed,
then press ;
11. "Confirm?": press
12. "Hot water, Confirm?": position a container under the hot
water spout (C6) (min. capacity: 500ml), then press
or to start delivery;
13. The appliance begins hot water delivery and the message
"Please wait" is displayed;
14. After the flow of hot water stops, the appliance automati-
cally resets to "Ready for coffee" status.
The filter is now active and you can use the coffee machine.

2.1 Replacing the filter

Replace the filter (C4) when "Replace filter, ESC to cancel, OK to
replace" appears on the display (B1). To replace immediately,
press (B3) and follow the instructions from point 8. To
replace the filter later, press
symbol to remind you that the filter needs replacing.
To replace, proceed as follows:
1. Extract the tank (A18) and exhausted filter;
2. Take the new filter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section;
3. Press to enter the "Settings" menu;
4. Press the selection arrows (B4 and B5) until "Maintenance"
is displayed between the two dotted lines: press
40
(B5) or to confirm;
(B2): the display shows the
5. Press the selection arrows until "Replace filter" is displayed,
then press
6. "Confirm?": press
7. "Hot water, Confirm?": position a container under the hot
water spout (C6) (min. capacity: 500ml), then press
or (fig. 5) to start delivery;
8. The appliance begins hot water delivery and the message
"Please wait" is displayed;
9. After the flow of hot water stops, the appliance automati-
cally resets to "Ready for coffee" status.
The new filter is now active and you can use the coffee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

2.2 Removing the filter

If you want to use the appliance without the filter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A18) and exhausted filter;
2. Press (B2) to enter the "Settings" menu;
3. Press the selection arrows (B4 and B5) until "Maintenance"
is displayed between the two dotted lines: press
(B3);
4. Press the selection arrows
"Remove filter" is displayed: press
5. "Confirm?": press
appliance goes back to the "Maintenance" menu;
Then press twice to exit the menu.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should remove/replace the filter
even if the message has not yet been displayed.

18. TECHNICAL DATA

Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Dimensions WxDxH:
Cord length:
Weight:
Max. beans container capacity: 250 g
Frequency:
Max transmit power
This product is compliant with Regulation (EC) No.
1935/2004 on materials and articles intended to come
;
into contact with food.
46
;
(B5) or to confirm;
(B4) or
;
or to confirm removal. The
220-240 V~ 50/60 Hz max. 10A
1450W
1.9MPa (19 bars)
2 l
240x465x350 mm
1750 mm
11.8 kg
2400 - 2483,5 MHz
10 mW
(B5) until