6. TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch
(A7) on the back of the appliance is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A14) and is collected in the drip tray (A24) underneath. Avoid
contact with splashes of water.
•
To turn the appliance on, press the
(fig. 6). The message "Heating, Please wait" appears on the
display (B1).
•
After heating, the message "Rinsing" is displayed, togeth-
er with a progress bar which gradually fills as preparation
proceeds. As well as heating the boiler, the appliance also
heats the internal circuits by circulating hot water.
The appliance is at temperature when the message "Select your
beverage" is displayed.
7. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A14). Avoid contact with splashes of water.
•
To turn the appliance off, press the
6);
•
The message "Turning off underway Please wait" appears
on the display (B1), then (if provided for) the appliance
performs a rinse cycle and goes off (standby).
Please note!
If the appliance is not used for an extended period, first com-
plete the "emptying" procedure (see section "8.3 Maintenance"-
"Emptying the circuit:") and then disconnect the appliance from
the mains power supply, as follows:
•
first turn the appliance off by pressing the
(fig. 6);
•
release the main switch (A7) (fig. 2).
Important!
Never press the main switch while the appliance is on.
8. MENU SETTINGS
The menu has 8 items, some divided into subgroups:
•
Rinsing;
•
Language;
button (A12)
button (A12-fig.
button
•
Maintenance:
- Descale,
- Install filter,
- (if a filter has been in-
stalled): Replace filter,
- (if a filter has been in-
stalled): Remove filter;
- Emptying the circuit;
•
Prg. beverages;
•
Prg. My beverages;
•
General:
- Set temperature,
8.1 Rinsing
Use this function to deliver hot water from the coffee spouts
(A14) and hot water/steam spout (C6), if inserted, to clean and
heat the appliance's internal circuit.
Place a container with a minimum capacity of 100ml under the
coffee and hot water spouts.
To enable the function, proceed as follows:
1. Press
(B2) to enter the menu;
2. Press the selection arrows
"Language" is displayed between the two dotted lines;
3. Press
(B3) to start rinsing.
Important! Danger of burns.
Do not leave the appliance unattended while hot water is being
delivered.
4. After a few seconds, hot water is delivered first from the
coffee spouts, then from the hot water/steam spout (if in-
serted) to clean and heat the appliance's internal circuit.
"Rinsing" appears on the display, together with a progress
bar which fills gradually as preparation proceeds;
5. To stop rinsing press
until it finishes automatically.
Please note!
•
If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
•
After cleaning, it is normal for the grounds container (A20)
to contain water.
8.2 Language
To modify the language of the display (B1), proceed as follows:
1. Press
(B2) to enter the "Settings" menu;
2. press the selection arrows
"Language" is displayed between the two dotted lines;
3. Press
(B3). The available languages are displayed;
4. press the selection arrows
quired language is displayed between the two dotted
lines;
5. Press
to confirm;
34
- Water hardness,
- Auto-off,
- Energy saving,
- Beep,
- Cup warmer,
- Cup lighting
- Default beverages,
- Default values;
•
Bluetooth
•
Statistics.
(B4) or
(B5) until
(B5) or
(B2) or wait
(B4) or
(B5) until
or
until the re-