Cleaning The Inside Of The Coffee Machine; Cleaning The Water Tank; Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel - DeLonghi PrimaDonna S Evo ECAM51 55 Series Instructions For Use Manual

14.2 Cleaning the inside of the coffee machine

Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see section "7. Turning the appliance off") and unplugged from
the mains power supply. Never immerse the coffee machine in
water.
1. Check regularly (about once a month) that the inside of
the appliance (accessible after removing the drip tray, A24)
is not dirty. If necessary, remove coffee deposits with the
brush (C5) supplied and a sponge;
2. Remove all the residues with a vacuum cleaner (fig. 25).

14.3 Cleaning the water tank

1. Clean the water tank (A18) regularly (about once a month)
and whenever you replace the water softener filter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the filter (C4) (if present) and rinse with running
water;
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank;
4. (Models with water softener filter only) Deliver 100ml of
water to reactivate the filter.

4.1 Cleaning the coffee spouts

1. Clean the coffee spouts (A14) regularly with a sponge or
cloth (fig. 26A);
2. Check that the holes in the coffee spouts are not blocked.
If necessary, remove coffee deposits with a toothpick (fig.
26B).

14.4 Cleaning the pre-ground coffee funnel

Check regularly (about once a month) that the pre-ground cof-
fee funnel (A6) is not blocked. If necessary, remove coffee de-
posits with the brush (C5) supplied.

14.5 Cleaning the infuser

The infuser (A9) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see "7. Turn-
ing the appliance off");
2. Remove the water tank (A18);
3. Open the infuser door (A10) (fig. 27) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 28);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
Rinse with water only
No washing up liquid - no dish washer
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support, then push the PUSH symbol fully in until it
clicks into place;
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers (fig. 29).
8. Once inserted, make sure the two coloured buttons have
snapped out;
9. Close the infuser door;
10. Put the water tank back.

14.6 Cleaning the milk container

Clean the milk container (D) each time you prepare milk as de-
scribed below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 30);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 31) and pull off upwards;
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dish-
washer safe, placing them in the top basket of the
dishwasher.
5. Make sure there are no milk residues on the hollow and
groove under the dial (fig. 32). If necessary, scrape the
groove with a toothpick;
6. Rinse inside the froth adjustment dial seat with running
water (fig. 33);
7. Check that the intake tube and milk spout are not clogged
with milk residues;
43
8. Replace the dial (in cor-
respondence to the word
"INSERT"), spout and milk
intake tube;
9. Place the lid back on the
milk container (D3).
33
A