11
SERVICE WORK ON THE CHASSIS
11.7
Fitting the seat
11.8
Mounting the helmet lock on the vehicle
Warning
Danger of accidents Impairment of vehicle handling and vehicle operation if a helmet or helmet lock is attached to the vehicle.
–
Do not use the helmet lock for holding a helmet or other objects during the journey. Always remove the helmet lock before start-
ing out.
–
Position the recesses of the seat to the lugs on the frame, lower the rear end and simul-
taneously push it forward.
–
Lock the seat by turning the ignition key in the seat lock.
–
Remove the ignition key from the seat lock.
–
Finally, check that the seat is correctly mounted.
B01323-10
–
Remove the seat. (
–
Position the steel cable from the tool kit with one loop on the lug
Steel cable (60012015000)
–
Guide the steel cable through the helmet opening.
–
Then position the free loop of the steel cable on the lug.
–
Position the helmet carefully on the side of the vehicle.
–
Fit the seat. (
B01324-10
p. 159)
p. 160)
160
.