18
CLEANING, CARE
18.1
Cleaning motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors, cables,
bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component. Excessive pres-
sure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
–
Close off the exhaust system to keep water from entering.
–
Remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty parts with a normal commercial engine cleaner and then brush off with
a soft brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water first.
401061-01
If the vehicle has been used on salted roads, clean it with cold water. Warm
water intensifies the effects of salt.
p. 262)
228