Table of Contents
Advertisement
20
TROUBLESHOOTING
Faults
Engine doesn't crank when the electric
starter button is pressed
Engine cranks only if the clutch lever
is pulled
Engine cranks although it is in gear
Engine cranks but doesn't start
Possible cause
Operating error
Battery discharged
Fuse 1 or 6 is blown
Main fuse blown
Ignition/steering lock or emergency
OFF switch defective
Safety start system defective
Immobilizer active
EFI control unit not activated
Malfunction in CAN bus communica-
tion
Combination instrument defective
A gear is engaged
Safety start system defective
Safety start system defective
Fuse 5 blown
The plug-in connection of the fuel hose
connection is not connected
Plug connector of wiring harness oxi-
dized
Action
–
Carry out the start procedure. (
–
Recharge the battery.
–
Check closed-circuit current.
–
Change the fuses of individual power consumers.
(
p. 200)
–
Change the main fuse. (
–
Check the ignition/steering lock.
–
Check the emergency OFF switch.
–
Read out the trouble code memory using the
KTM diagnostics tool.
–
Read the immobilizer blink code.
–
Encode the EFI control unit.
–
Read out the trouble code memory using the
KTM diagnostics tool.
–
Check the combination instrument.
–
Shift into neutral.
–
Read out the trouble code memory using the
KTM diagnostics tool.
–
Read out the trouble code memory using the
KTM diagnostics tool.
–
Change the fuses of individual power consumers.
(
p. 200)
–
Connect the plug-in connection of the fuel line.
–
Clean plug connector and treat with contact
spray.
233
p. 109)
(
p. 195)
p. 198)
Advertisement
Table of Contents
