Setting Up Postscript Or Pcl Printing With Windows 2000/Xp/Server 2003; Installing The Postscript Or Pcl Printer Driver; For Windows 2000/Xp/Server 2003 - Sharp AR-C360P Software Installation Manual

1
1-44 Installing User Software on a Windows Computer
Setting up PostScript or PCL printing with
Windows 2000/XP/Server 2003
To set up the Fiery as a PostScript or PCL printer, you must install
the PostScript or PCL printer driver for Windows 2000/XP/Server
2003 and the corresponding printer description files. You must
also configure the print connection between the computer and the
Fiery. If you are printing over a network, you must configure a
network connection. If you are printing directly to the printer, you
must configure a parallel port connection.
Note:
driver.
Note:
and PCL printer drivers are similar.

Installing the PostScript or PCL printer driver

for Windows 2000/XP/Server 2003

The following procedure describes installing the printer driver
from the Drivers CD (CD1). Subsequent procedures describe
setting up the print connection.
To install the PostScript or PCL printer driver
for Windows 2000/XP/Server 2003
1. Insert CD1 into your CD drive and wait for the CD to autorun the setup
program.
If the CD does not autorun navigate to the CD root directory and
double-click the setup.exe program to start the installer.
Sharp AR-C360P EFI User's Software Installation Guide - 44
For Windows Server 2003, use the Windows XP printer
The procedures for configuring the options for the PostScript