Setting Up Postscript Or Pcl Printing With Windows 98/Me; Installing The Postscript Or Pcl Printer Driver; For Windows 98/Me - Sharp AR-C360P Software Installation Manual

1

1-17 Setting up PostScript or PCL printing with Windows 98/Me

Setting up PostScript or PCL printing with
Windows 98/Me
To set up the Fiery as a PostScript or PCL printer, you must install
the PostScript or PCL printer driver for Windows 98/Me and, for
PostScript, the corresponding printer description file. You must
also configure either a local connection for printing directly or a
network connection for printing over the network.
If you are printing using SMB (Server Message Block), you can
connect to the Fiery and install the printer drivers in a single
procedure. For more information, see
with Windows 98/Me"
Note:
and PCL printer drivers are similar. Either can, and should, be
installed using the Installer program on CD1 supplied with the
Sharp AR-C360P.
Installing the PostScript or PCL printer driver for
Windows 98/Me
The following procedure describes installing the printer driver
from CD1. Subsequent procedures describe configuring installable
options and setting up the printer connection.
Note:
Drivers CD (CD1) to install the printer drivers. This will
automatically also install the Sharp LPR utility, which greatly
simplifies network connection to the printer over a TCP/IP
connection. If you choose to use the standard Windows Add
Printer Wizard, you will need to install this utility from the CD
afterwards if you require these features.
To install the PostScript or PCL printer driver

for Windows 98/Me

1. Insert CD1 into your CD drive and wait for the CD to autorun the setup
program.
Sharp AR-C360P EFI User's Software Installation Guide - 17
on page 1-29.
The procedures for setting up printing with the PostScript
It is strongly recommended that you use the supplied
"Setting up SMB printing