Table of Contents
Advertisement
If chain paper feeding is abnormal, please check according to the form below.
Inspection
Is the release lever is at the position of
this icon
?
Are the paper holes in the right
position?
Are the two paper clips are too near or
too far from each other?
Are Paper clips locked or covered?
Is the feeding path unhindered?
Feeding by pressing the key when
online?
Is the paper too thick?
If failing in rejecting paper, please check according to the form below.
Check
Is the release lever at the position of
this icon
?
Does the printer reject paper
normally?
If the page length, page heading and page footing are not as good as expected, please check
according to the form below.
Check
Is the position of the first line too high or
too low?
Does the page length meet the actual
requirement?
Stir release lever to this icon
Aligning the holes.
The distance between the two paper clips will affect
feeding. Adjust it appropriately if not.
Make sure paper clips are locked and covered.
The distance between chain paper place and printer
shouldn't exceed 1m, and the path should be smooth, or
it will cause paper jam.
Feeding key is valid when offline.
There is a limit to the thickness of paper, please refer to
Chapter 2.2.1.
Solutions
Release lever should be at the icon position
you use chain paper.
Check if the PAPER OUT light is on after rejecting.
Solutions
Adjust it by feeding a little.
Adjust it by software command mode or EDS switch
settings.
29
Solutions
position.
when
Advertisement
Table of Contents
