Setting Up The Adjust Lever - Print-Rite PR-855 User Manual

24-pin dot matrix printer
Table of Contents

Advertisement

2.4 Setting up the Adjust Lever

To get the best printing effect while protecting the printhead, please make sure adjust the lever
correctly according to the total thickness of printing paper. The bigger the number of adust lever
setting, the thicker the papers that can be printed. If the printout appears dim or the character
appears to be missed or missing, the value of this setting may be too high. Instead, if the value of
this setting is too low, the printout may be dirty, and the paper feeding may be incorrect or the
ribbon may be damaged. Please refer to the data given in the table below to select the
appropriate lever position.
Paper type
Plain paper
Multi-layer copy
paper(carbonless)
Name card
When the adjustment lever is toggled from high level to 2 or below, the printer will sound a bee. The
printer will sound two chirps when the adjustment lever is toggled from low level to 3 or above ,
which indicate it entries into multi-layer mode.
Note: Please set the printer to multi-layer mode when you use wax paper.
This printer is applicable to the recycled paper.
single paper
chain paper
2(original+1 copy)
3(original+2 copies)
4(original+3 copies)
5(original+4 copies)
6(original+5 copies)
7(original+6 copies)
13
Adjust lever
position
1 or 2
1 or 2
2
3
4
5
6
7
5 or 6

Advertisement

Table of Contents
loading

Table of Contents