Table of Contents
Advertisement
below.
Inspection
Are the table lines out of alignment? Adjust the longitudinal calibration parameters.
If the application software cannot print the selected character or font, please check according to
the form below.
Inspection
Is the application software properly
installed?
Is the correct font selected?
Is the printing character different
from inputting character?
If the printing result is different from requirement, please check according to the form below.
Inspection
Is the printout not good as expected?
3)
Paper feeding
If a single sheet paper does not feed smoothly, please check according to the form below.
Inspection
Is the release lever pushed back the
position of this icon
Feeding by pressing the key in the
online state?
Is the paper too thick?
Reinstall it if necessary.
Make sure the settings are correct, try to transfer the
fonts.
Maybe the national character group setting goes is
wrong, or you select wrong character set. Deal with it
by software.
Select HEX printing, analyze the data from computer, it
can help tracking the path of error.
Stir release lever to this icon
?
Feeding key is valid when offline.
There is a limit to the thickness of paper, please refer to
Chapter 2.2.1.
Solutions
Solutions
Solutions
Solutions
28
position.
Advertisement
Table of Contents
