Table of Contents
Advertisement
7)
Install the printing paper according to the one in the middle with a " 〇 "below, close the
paper gap and check if the hole are aligned with the sprocket, if not, It may cause the paper
to tear or jam during paper walking.
8)
Turn on the printer power switch, you will hear a beep which means paper out, the
indicator light will be on. Press [LOAD/EJECT], printer will feed automatically to the print
start position.
2.3 Flat-bed Paper Feeding
2.3.1 Flat-bed Paper Feeding with Single Paper and Multi-layer Paper
When you print by flat-bed, no need to take down the chain paper, but you need to reject
the chain paper to the feeding position.
For paper path, you can choose to feed and reject from the front, or feed from the front and
reject from the back. Details please refer to chapter 4.
2.3.2 Flat-bed Paper Feeding
1)
Check the position of release lever, as shown in Fig. 2-11, adjust the release lever to the
back(which is the flat-bed icon position).
Fig. 2-10
Fig. 2-11
11
Advertisement
Table of Contents
