Table of Contents
Advertisement
12
Enhance printing
13
Pin power
(single paper)
14
Pin power
(multi-layer paper)
15
Pin power(enhance)
1)
Emulation mode
ESC/P: Adopt ESC/P control code standard.
OKI: Adopt OKI 5330 control code standard.
2)
Paper tearing type
For continuous chain paper,
Long: After printing the whole text, one page comes out by manual or automatic tearing
according to the length of the paper.
Short: After printing the whole text, the paper comes out about 2 inches by manual or
automatic tearing.
3)
Tear paper automatically
For continuous chain paper,
Invalid-- Manually tear off
Valid-- Auto tear off
Manualy tear off: after prin ting the whole text, press [LOAD/UNLOAD] in online state,
1
the paper will go to the tear paper position automatically. Press [LOAD/UNLOAD] again, the
paper will reject to the initial position of the next page and printer starts to print.
Auto tear off: When the text is printed and no data is printed within 1-2 seconds, the
2
printer will automatically move the paper out to the tear off position. When new data is received ,
the paper returns to the start position of the next page and starts a new page printing. Auto Tear
off is valid for any page length.
4)
Image print direction
Dot matrix images
Bi-D: bidirectional printout (in alternate directions) to improve the speed.
Uni-D: unidirectional printing (from left to right) to improve accuracy.
5)
Paper-out direction(flat-bed feeding)
Front out : paper out from the feeding direction
Rear out : paper out from the back of the printer.
Invalid
3
2
1
21
Valid
1 ~ 4
1 ~ 4
1 ~ 3
Advertisement
Table of Contents
