Power On Functions - Print-Rite PR-855 User Manual

small steps until the keys are released.
Press [ONLINE] and hold, press[LOAD/UNLOAD], printer will reject the paper continuously in
small steps until the keys are released.
Page head settings

When printer is offline.
Press [ONLINE] for about 2 seconds, release it when you hear a beep, then press [TEAR OFF] and
hold, printer will feed continuously till you release the key. If you press [LOAD/UNLOAD] and hold,
printer will reject the paper continuously until you release the key.
Note: When using punch paper, do not attempt to return the paper to the top page, as the
printer paper may get stuck inside the printer.
After the adjustment, press [ONLINE] and hear a beep, paper head position is saved at present, if
you want to save the settings permanently, please press [ONLINE] for about 2 seconds and hear
two beeps, the current page top position is saved already and will not lost after power off.
Note: The range of head space is 0-4 inch. It will stop automatically when reach to 0 inch, and
you cannot save the settings if exceed 4 inches, it will reset to defaults after power on.
Clear the buffer area

Printer will store the received data in the buffer area. If you stop printing accidentally, the data in the
buffer area will cause messy code when you start printing again, so you need to turn off the power and
clear this part of data.

3.3 Power on Functions

There are some special functions by pressing different keys and power on the printer at the same
time.
Self-checking

Press [ONLINE] and power on the printer at the same time, the printer will conduct self-checking, print
ROM version number and EDS settings.
Printer will stop self-checking when power off.
HEX printing

Printing by this mode is good for analyzing the problems when there is an error.
Press [TEAR OFF] and power on the printer at the same time, printer switches to HEX printing
mode when you hear a beep.
Log out the printer HEX printing mode when power off.
EDS settings

Press [PRINT MODE] and power on the printer at the same time, the printer will enter into EDS
16