Table of Contents
Advertisement
Coil Tine Installation
1. Assemble 2-1/2" adjustment pin into plates welded
onto rear of frame using 2-1/2" snap rings to secure.
On the outer wings install large outer slot of reel arm
stop over the adjustment pin in between the plates
before installing snap rings. The reel arm stop will be
in between the plates welded to the frame but
mounted to the outer end of the reel. Note in pages
2-14 through 2-19 where the two tine arm mounts
are located requiring u-bolts to mount them.
2. Assemble 1 x 8 adjustment bolt through adjustment
pin, 1" lock washer, (2) 1-8 hex nuts, and 17" heavy
spring assembly. On the outer wings place the reel
arm stop on the correct side of the 1x8 adjustment
bolt as shown on pages 2-14 through 2-19.
3. Install 1-1/2" flange bearing into tine arm. Slide in
1-1/2" pivot bushing.
4. Attach tine arm to upper hole on rear center or wing
frame or u-bolt mount using 1-8 x 6-1/2 hex head cap
screw and hex lock nut.
ASSEMBLY INSTRUCTIONS
5. Assemble 17" heavy spring assembly to tine arm
using 1" pivot pin and 5/16 x 1-1/2 spring slotted pins.
Set pin centers to 20-1/2" dimension as shown in
Figure 3-23. On the outer wings the reel arm stop
will replace the machinery bushing on the outside of
the tine arm. This will prevent the tine from hanging
down so far while the machine is being folded.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
6. Attach tine assemblies to arms using tube clamp,
gang bar mount plate, 3/4-10x7 hex head cap screws
and double hex lock nuts. Note direction of tube
clamp with opening facing down. Refer to pages
2-14 through 2-19 for tine mounting locations.
7. Attach yellow reflector decals on outer arms. The
decals are located in the manual tube. Reflector
decal locations also shown on pages 2-14 through
2-19.
WARNING
3-27
Advertisement
Table of Contents
