Configuring Level Measurement; Configuring Pressure Measurement; Backing Up Or Duplicating The Device Data - Endress+Hauser Cerabar M PMC51 Brief Operating Instructions

Cerabar M PMC51, PMP51, PMP55
Selection
Factory setting
Pos. zero adjust (007) (gauge pressure sensors)
Write permission
Description
Example
Selection
Factory setting
8.4

Configuring level measurement

See the Operating Instructions.
8.5

Configuring pressure measurement

See the Operating Instructions.
8.6

Backing up or duplicating the device data

See the Operating Instructions.
Endress+Hauser
• Confirm
• Cancel
Cancel
Operator/Maintenance/Expert
Pos. zero adjustment – the pressure difference between
zero (set point) and the measured pressure need not be
known.
• Measured value = 2.2 mbar (0.033 psi)
• You correct the measured value via the "Pos. zero adjust"
parameter with the "Confirm" option. This means that you
are assigning the value 0.0 to the pressure present.
• Measured value (after pos. zero adjustment) = 0.0 mbar
• The current value is also corrected.
• Confirm
• Cancel
Cancel
Commissioning
31