Table of Contents
Advertisement
7 MAINTENANCE
4.
Remove the four screws holding the left side panel (L) and remove the panel.
5.
Clean the left side of the power source, using dry compressed air with reduced
pressure.
6.
Make sure that there is no dust left on any part of the power source.
7.
After having finished cleaning the power source, reattach the power source panels in
the reverse order.
NOTE!
When reattaching the right side panel, make sure the IP shield on the inside
of the panel is in the correct position. The IP shield should be angled
approximately 90° into the power source, so that it is positioned between the
welding outlet connector and the transformer outlets.
0463 416 101
- 35 -
© ESAB AB 2022
Advertisement
Table of Contents
