Table of Contents
Advertisement
6 CONTROL PANEL
6.2
ET 300iP
1.
Button to change between direct
current and pulse current.
2.
Display, shows set or measured value.
3.
Button to select welding method: TIG
HF, LiftArc™ or MMA.
4.
Set indicator.
5.
Button to select 2-stroke or 4-stroke
(TIG only).
6.
Button to activate and deactivate
remote control unit.
7.
Knob for setting data.
8.
Gas pre flow indicator.
9.
Slope up indicator.
10.
Direct current or pulse current indicator.
11.
Pulse balance.
0463 416 101
12.
Background current indicator.
13.
Pulse frequency indicator.
14.
Slope down indicator.
15.
Gas post flow indicator.
16.
Button to change between the
parameters in the graph.
17.
Indicates which is shown in the display:
s (seconds for gas pre flow, gas post flow,
slope up and slope down), % (pulse
balance), Hz (pulse frequency).
18.
Current set and measure value / Voltage
measure value.
19.
Parameter selection button, selection
indicated by (18). Also used for access to
hidden functions.
20.
Overheating indicator.
21.
VRD function (reduced open-circuit
voltage) indicator.
- 23 -
© ESAB AB 2022
Advertisement
Table of Contents
