Toro Groundsmaster 4110 Operator's Manual page 27

to attain the desired height of cut; then slide the
washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting
16):
6. Push the caster spindle through the front caster
arm.
7. Install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft.
8. Install the tensioning cap to secure the assembly.
9. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the mower deck
1. Height-of-cut chain
10. Mount the height-of-cut chains to the desired
height-of-cut hole with the clevis pin and hairpin
cotter (Figure 18).
Figure 16
(Figure 17).
1
2
g020968
Figure 17
2. Clevis pin and hairpin
cotter
(Figure
Note:
(1-1/2 inch), or occasionally 51 mm (2 inch)
decal100-5622nc
height-of-cut, move the skids and gage wheels
to the highest position.
Wing Mower Decks
To adjust the height-of-cut on the wing mower decks,
add or remove an equal number of spacers from the
caster forks, position the caster-wheel axles in the
high or low height-of-cut holes in the caster forks, and
secure the pivot arms to the selected height-of-cut
bracket holes.
1. Position the caster-wheel axles in the same
holes in all of the caster forks
Figure
2. Remove the tensioning cap from the spindle
shaft and slide the spindle out of the caster arm
(Figure
g020968
1. Tensioning cap
2. Spacers
3. Shims
3. Install 2 shims onto the spindle shaft as they
were originally installed.
27
Figure 18
When using 25 mm (1 inch), 38 mm
21).
19).
Figure 19
4. Top axle-mounting hole
5. Caster wheel
decal106-4251nc
(Figure 19 and
g008866