Toro Groundsmaster 4110 Operator's Manual page 18

Parking-Brake Latch
A knob on the left side of the console actuates the
parking-brake lock (Figure
To set the parking brake, connect the pedals with the
locking latch, push down on both pedals, and pull
out the parking-brake latch. To release the parking
brake, press both pedals until the parking-brake latch
retracts.
Hazard-Light Switch (Optional)
Press the hazard-light switch to activate the hazard
lights (Figure 3).
Turn-Signal Switch (Optional)
Press the left side of the turn-signal switch to activate
the left-turn signal and the right side of the switch to
activate the right-turn signal
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
3
2
4
5
6
7
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (Figure
By momentarily tapping the switch, you can increase
or decrease the engine speed in 100-rpm increments.
When you hold the switch down, the engine
automatically moves to H
on which switch you press.
3).
(Figure 3).
4) has 3 positions: O
.
1
Figure 4
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
4).
or L , depending
IGH OW IDLE
PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
Lift Switches
The lift switches raise and lower the mower decks
(Figure 4). Press the switches forward to lower the
mower decks and rearward to raise the mower decks.
When starting the machine, with the mower decks in
the down position, press the lift switch down to allow
the mower decks to float and mow.
Note:
The decks do not lower while in the High-speed
range and they do not raise or lower if the operator is
out of the seat when the engine is running. Also, the
decks lower with the key in the O
operator in the seat.
Cruise-Control Switch
,
FF The cruise-control switch locks in the pedal position
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the R
also disengages the pedal position.
g028453
g028453
g028454
1. Power-point port
Power-Point Port
The power-point port is used to power optional
electrical accessories
18
(
UT START
(Figure 4).
position and the
N
(Figure
position, for 1 second,
EVERSE
1
2
Figure 5
2. Cruise-control switch
(Figure 5).
) and
5).
g028454