Toro Groundsmaster 4110 Operator's Manual page 76

2. Set the mower deck to the desired height of cut.
3. Rotate a blade to point straight forward.
4. Using a short ruler, measure from the floor to
the front tip of the blade.
5. Rotate the blade tip to the rear and measure
from the floor to the tip of the blade.
6. Subtract the front dimension from the rear
dimension to calculate the blade pitch.
Adjusting the Center Mower-Deck
Pitch
1. Loosen the jam nuts on the top or bottom of the
height-of-cut-chain U-bolt
2. Adjust the other set of nuts to raise or lower the
rear of the mower deck and attain the correct
mower-deck pitch.
3. Tighten the jam nuts.
Figure 109
1. U-bolt
Adjusting the Wing Mower Decks
1. Remove the cap screws and nuts securing the
castor arm to the castor fork
2. Position the shims, as required, to raise or lower
the castor wheel until the mower deck has the
correct pitch.
3. Install the cap screws and nuts.
(Figure 109).
1
2
g020969
g020969
2. Height-of-cut chain
(Figure 110).
1. Castor arm
2. Shims
76
Figure 110
3. Castor fork
g011561