Table of Contents
Advertisement
3. Tighten the jam nut
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and adjust
or replace it if necessary.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1.5 mm (1/16 inch) as shown in
(Figure
44).
Figure 44
2. Turnbuckle
(Figure
Figure 45
Figure
46.
1. Tab
2. 1.5 mm (1/16 inch)
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut
45).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed on
the belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
20
Figure 46
(Figure
47).
Figure 47
2. Turnbuckle
(Figure
47).
Advertisement
Table of Contents
