Table of Contents
Advertisement
•
Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
•
Stay alert for hidden hazards or traffic.
•
After striking a foreign object, shut off the engine,
remove the ignition key, thoroughly inspect the machine
for any damage, and repair the damage before starting
and operating the machine.
•
If the machine should start to vibrate abnormally, shut off
the engine and check immediately for the cause.
•
Do not run the engine indoors, except when starting
the engine and for transporting the machine in or out
of the building. Open the outside doors; exhaust fumes
are dangerous.
•
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
•
Never touch a hot engine or muffler.
•
Thoroughly inspect the electrical cord before plugging
it into a power source. If the cord is damaged, do not
use it to start the machine. Replace the damaged cord
immediately. Unplug the power cord whenever you are
not starting the machine.
Starting the Engine
1. Check the engine-oil level; refer to
Engine-Oil Level (page
2. Turn the fuel-shutoff valve 1/4 turn counterclockwise
to open it
(Figure
24).
6 Checking the
9).
G016512
Figure 24
3. Insert the ignition key all the way in
G016498
1. Ignition key
4. Firmly push in the primer with your thumb as indicated
by the table below, holding the primer in for a second
before releasing it each time
Temperature
Above -18°C (0°F)
-23°C to -18°C (-10°F to 0°F)
Below -23°C (-10°F)
g037221
12
(Figure
Figure 25
(Figure
26).
Suggested Number of
Primes
3
4
6
Figure 26
25).
1
Advertisement
Table of Contents
