Table of Contents
Advertisement
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the
pin until it is the proper gap from the front edge
of the slot.
3. Tighten the jam nut
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and
adjust or replace it if necessary.
1. Remove the 2 screws from the right side of the
belt cover as shown.
2. Lift up the right side of the belt cover
3. With the auger/impeller lever disengaged,
ensure that the gap between the auger clutch
assembly and the tab is 1.5 mm (1/16 inch) as
shown in
Figure
(Figure
43).
Figure 43
2. Turnbuckle
(Figure
Figure 44
45.
1. Tab
2. 1.5 mm (1/16 inch)
g001021
4. If the auger/impeller cable is not properly
adjusted, do the following steps:
5. Loosen the jam nut
44).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed
g001022
on the belt cover.
10. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
22
Figure 45
(Figure
46).
Figure 46
2. Turnbuckle
(Figure
46).
g001569
g001024
Advertisement
Table of Contents
