Table of Contents
Advertisement
Shutting Off the Engine
1. Move the throttle to the S
the S
position
TOP
You can also shut off the engine by pulling the ignition
key outward to the middle position.
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key to prevent accidental starting.
4. Close the fuel shutoff valve by rotating it clockwise
(Figure
31).
5. Pull the recoil starter 3 or 4 times.
Note: This helps prevent the recoil starter from
freezing up.
position, and then to
LOW
(Figure
30) to shut off the engine.
G016505
Figure 30
G016499
Figure 31
Operating the Handwarmers
Operate the handwarmers as follows:
•
Flip the switch to the O
handwarmers.
•
Flip the switch to the O
handwarmers.
1. On/off switch
2. O
position
N
Operating the Traction Drive
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to
Adjusting the Traction Cable (page 19)
information.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable;
refer to
Checking and Adjusting the Traction Cable
(page 19)
or take the machine to an Authorized Service
Dealer for service.
1. To engage the traction drive, squeeze the left (traction)
lever to the handgrip
14
position to turn on the
N
position to turn off the
FF
Figure 32
3. O
position
FF
Checking and
for more
(Figure
33).
Advertisement
Table of Contents
