Checking And Adjusting The Auger/Impeller Cable - Toro Power Max Heavy Duty 928 OHXE Operator's Manual

1. Pin
2. 1 to 1.5 mm (1/32 to 1/16 inch)
If the left (traction) cable is not properly adjusted, do the
following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3. Tighten the jam nut
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and adjust
or replace it if necessary.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover
Figure 43
(Figure 44).
Figure 44
2. Turnbuckle
(Figure
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1.5 mm (1/16 inch) as shown in
1. Tab
2. 1.5 mm (1/16 inch)
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut
45).
1. Jam nut
22
Figure 45
Figure 46.
Figure 46
(Figure 47).
Figure 47
2. Turnbuckle