Table of Contents
Advertisement
Figure 60
4. Insert a new bulb into the back of the headlight
61).
Figure 61
5. Turn the base of the bulb clockwise until it is snug
(Figure
62).
Figure 62
6. Insert the wire connector straight into the back of the
headlight until it is securely in place
Figure 63
Storage
• Fuel vapors can explode.
• Do not store fuel more than 30 days.
• Do not store the machine in an enclosure near
(Figure
• Allow the engine to cool before storing it.
Preparing the Machine for
Storage
1. On the last refueling of the year, add fuel stabilizer to
2. Run the engine for 10 minutes to distribute the
3. Run the machine until the engine runs out of fuel.
4. Prime the engine and start it again.
5. Allow the engine to run until it shuts off. When you
6. Shut off the engine and allow it to cool.
7. Remove the ignition key.
8. Clean the machine thoroughly.
9. Touch up chipped surfaces with paint available from an
(Figure
63).
10. Tighten all loose screws, bolts, and locknuts. Repair or
11. Cover the machine and store it in a clean, dry place out
Removing the Machine from
Storage
Perform the annual maintenance procedures as given in the
Recommended Maintenance Schedule; refer to
(page
24
WARNING
an open flame.
fresh fuel.
Note: Fuel should not be stored longer than suggested
by the fuel stabilizer manufacturer.
conditioned fuel through the fuel system.
can no longer start the engine, it is sufficiently dry.
Authorized Service Dealer. Sand affected areas before
painting, and use a rust preventative to prevent the
metal parts from rusting.
replace any damaged parts.
of the reach of children.
18).
Maintenance
Advertisement
Table of Contents
