Every 500 Service Hours Or 1 Year; Changing Engine Oil; Replacing Water Separator Filter (Type 2); Every 500 Service Hours Or 2 Years - Kubota V2403-CR-TIE4-BG Operator's Manual

EVERY 500 SERVICE HOURS OR 1 YEAR

BChanging engine oil
[V2607-CR-TIE4, V3307-CR-TIE4,
V3800-TIE4]
To avoid personal injury or death:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 500 hours thereafter. When the annual
operating hours are below 500, replace the oil every
year.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier when
the oil is warm.
[V2607-CR-TIE4, V3307-CR-TIE4, V3307-TIE4A]
(1) Oil drain plug
[V3800-TIE4]
(1) Oil drain plug
REGULAR CHECKS AND MAINTENANCE WORK
V3307-TIE4A,
underneath the
3. When letting out the oil, remove the filler plug too. With
the filler plug still in place, it would be difficult to
discharge the oil completely.
4. Add new engine oil up to the upper limit of the oil level
gauge. Be careful not to add oil above the upper limit
of the oil level gauge.
BReplacing water separator filter (Type 2)
1. Replace the water separator filter with a new one
every 500 hours or 1 year.
2. Remove the old water separator filter with a filter
wrench.
3. Apply a film of oil to the gasket for the new water
separator filter.
4. Screw in the water separator filter by hand. Because,
if you tighten the water separator filter with a wrench,
it will be tightened too much.
(1) Water separator filter
A Replace the water separator filter periodically to
prevent wear of the supply pump or the injector, due
to dirt in the fuel.

EVERY 500 SERVICE HOURS OR 2 YEARS

BReplacing fan belt
[V2607-CR-TIE4, V3307-CR-TIE4,
V3800-TIE4]
Consult your local KUBOTA Dealer for this service.
(See "Adjusting fan belt tension" in "EVERY 250
SERVICE HOURS" in "REGULAR CHECKS AND
MAINTENANCE WORK" section.)

EVERY 1000 SERVICE HOURS

BChecking valve clearance
Consult your local KUBOTA Dealer for this service.
27
V3307-TIE4A,