Kubota V2403-CR-TIE4-BG Operator's Manual page 28

16 MAINTENANCE
[V2607-CR-TIE4, V3307-CR-TIE4, V3307-TIE4A]
(1) Oil filler plug
(2) Oil level gauge
[V3800-TIE4]
(1) Oil filler plug
(2) Oil level gauge
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
4. If the oil level is too low, remove the oil filler plug, and
add new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes some time for the oil to drain
down to the oil pan.
Models
D1803-CR-TIE4
V2403-CR-TIE4
V2403-CR-TE4-BG
V2403-CR-TIE4-BG
V2607-CR-TIE4
V3307-CR-TIE4
V3307-TIE4A
V3800-TIE4
A Engine oil should be American Petroleum Institute
(API) service classification CJ-4 or CK- 4.
A Change the type of engine oil according to the
ambient temperature.
Above 25 C (77 F) 10W-30 or 10W-40 or 15W-40
-10 C to 25 C
10W-30 or 10W-40 or 15W-40
(14 F to 77 F)
Below -10 C (14 F) 10W-30 or 10W-40
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before adding
the new engine oil.
A Use of the following oil not only disallows the engine
from performing well in low temperatures until it
warms up sufficiently but may also lead to excessive
engine wear or engine seizure.
A Oil with a viscosity higher than 10W-30
A Oil not recommended by KUBOTA
A Be sure to inspect the engine, locating it on a level
place. If placed on gradients, oil quantity may not be
accurately.
Engine oil quantity
7.0 L (1.85 U.S. gals.)
9.5 L (2.51 U.S. gals.)
10.2 L (2.69 U.S. gals.)
11.2 L (2.95 U.S. gals.)
13.2 L (3.49 U.S. gals.)