Replacement Of Fuel Filter Cartridge; Every 500 Service Hours; Changing Of Engine Oil; Replacement Of Oil Filter Cartridge - Kubota D1803-CR-TIE4 Operator's Manual

24 REGULAR CHECKS AND MAINTENANCE WORK
BReplacement of fuel filter cartridge
[D1803-CR-TIE4, V2403-CR-TIE4]
1. Replace the fuel filter cartridge with a new one every
400 operating hours.
2. Apply fuel oil thinly over the gasket and tighten the
cartridge into position by hand-tightening only.
3. Finally, vent the air.
A Replace the fuel filter cartridge periodically to prevent
wear of the supply pump or the injector, due to dirt in
the fuel.
A The fuel filter cartridge and water separator should be
replaced earlier according to the fuel classification in
use.

EVERY 500 SERVICE HOURS

BChanging of engine oil
[V2607-CR-TIE4, V3307-CR-TIE4, V3800-TIE4]
To avoid personal injury or death:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 500 hours thereafter. When the annual
operating hours are below 500, replace the oil every
year.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier when
the oil is warm.
[V2607-CR-TIE4, V3307-CR-TIE4]
(1) Oil drain plug
underneath the
[V3800-TIE4]
(1) Oil drain plug
3. When letting out the oil, remove the filler plug too. With
the filler plug still in place, it would be difficult to
discharge the oil completely.
4. Add new engine oil up to the upper limit of the oil level
gauge. Be careful not to add oil above the upper limit
of the oil level gauge.
BReplacement of oil filter cartridge
[V2607-CR-TIE4, V3307-CR-TIE4, V3800-TIE4]
To avoid personal injury or death:
A Be sure to stop the engine before
changing the oil filter cartridge.
A Allow engine
sufficiently, oil can be hot and cause
burns.
1. Replace the oil filter cartridge. Oil filter cartridge
should be replaced after the initial 50 hours of
operation and every 500 hours thereafter.
2. Remove the old oil filter cartridge with a filter wrench.
3. Apply a film of oil to the gasket for the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge enough
by hand. Because, if you tighten the cartridge with a
wrench, it will be tightened too much.
to cool down