Look Solutions COBRA 3.1 Operating Manual page 17

The Flash mode is preset by default. It is recommended to use the Toggle mode only
when using the radio remote control.
The advantage here is that the start button on the transmitter does not have to be held
down permanently.
Fig. 12: Setting Toggle
In Toggle mode, briefly pressing the Start button on the transmitter of the radio remote
control starts the output.
Another short press ends the output.
The Toggle mode corresponds to the LATCHED mode on the version 1 and 2 devices.
This allows the available radio remote control to be used in combination with the device
without having to keep the start button on the remote control permanently pressed.
It is also recommended to set the pump value (FOG) to 100% so that the full fog output
can be used. If the value is preset to e.g. 65%, the connected remote/desk controls between
0 and 65% as maximum value.
Note
In contrast to the devices version 1 and 2 the toggle mode can also be terminated by
switching to flash mode or changing the source.
• Pressing < in the upper left corner returns to the previous screen without saving the
changes.
• Pressing ✔ saves the settings and returns to the main menu. Analog is now selected as
the source.
Please note that the selected pump characteristic has an influence on the fog quantity.
This means that even when manually set to 100%, less fog may be produced.
For more information, see section 5.6.1.
5. Operating the Cobra 3.1
17