Listening To The Radio - Sanyo AWM-660 Instruction Manual

LISTENING TO THE RADIO

FREQUENCY UP/DOWN TUNING
Automatic tuning
1
2
1. Press [FUNCTION] (or [TUNER/BAND] on the remote control)
to select AM or FM. The radio frequency appears.
or
2. Press [TUNING +] or [TUNING -] for at least 1 second to tune in
a station. The unit will scan up or down the band and receive
the next receivable station. Press the button again to continue.
• The [TUNING +] or [TUNING -] on the remote control can
also be used.
- TUNING +
Manual tuning
1. Press [FUNCTION] to select AM or FM.
2. Press [TUNING +] or [TUNING -] continuously until you are close
to the desired frequency, then press it briefly until the desired
frequency is displayed. Each time the button is pressed, the
frequency changes in 200 kHz steps for FM and 10 kHz steps
for AM.
Need help? Call
1-800-813-3435
AWM-660/US Eng page 11
TO PRESET STATIONS (Remote control only)
Up to 20 FM and 12 AM stations can be preset.
3
2
2,4
1
1. Tune in the station to be preset as described above.
2. Press [MEMORY].
3. Press [TU PRESET] to select the channel number to be preset.
• The number buttons on the remote control can also be used.
Two buttons must always be pressed.
Example:
To select No. 9, press [0], then [9].
To select No. 10, press [1], then [0].
4. Press [MEMORY].
• If using the number buttons on the remote control, this step is
not necessary.
• In this example, "103.1 MHz" FM station is preset on FM chan-
nel number 9.
NOTE:
If the next step is not taken within 10 seconds while performing
steps 2 - 4. "PROG." disappears and the preset operation is
cancelled. Press [MEMORY] to continue.
5. Repeat the steps above to add more preset stations.
• When presetting a new station, the previously preset station on
the same program number of the same band is cleared.
• The preset stations will be retained in the memory even if the
unit is turned off.
• If the memory contents are lost due to a power failure or other
condition, program the stations again.
-E10-
4/16/04, 5:40 PM