Download  Print this page

Listening To The Radio - Sanyo DC-F450 Instruction Manual

Hide thumbs

Advertisement

LISTENING TO THE RADIO
ii
To turn the unit on and listen to the last received station, press the
BAND button.
Manual tuning
1.
Press the BAND button to select FM or AM.
"TUNER"
is selected
automatically.
'TUNE
appears
on the
display, then 'TUNE
is replaced by the tuner mode display.
2.
Press the+ or–TUNING
button continuously
until you are close to the
desired frequency, then press it briefly until the desired frequency is
displayed. Each time the button is pressed, the frequency changes in
0.05 MHz steps for FM, 9 kHz steps for AM.
FM
103.25MM
•E
1234
5678
9 1011 1 2
13,4 1516
To preset stations
Up to 16 stations each for FM and AM bands can be preset.
1.
Tune in the station to be preset as described in "Manual tuning"
5.
Repeat the steps above to add more preset stations.
When presetting a new station, the previously preset station on the
same channel number of the same band is cleared.
The preset stations will be retained in the memory even if the unit is
turned off.
If the memory
contents
are lost due to a power failure or other
condition,
preset the stations again.
Listening to preset stations
1.
Press the BAND button to select FM or AM.
2.
Press the+or-PRESETbuHon
toselectthedesired
channel number.
The selected channel number blinks on the display.
The number buttons on the remote control can also be used.
Press two number buttons within 4 seconds.
To receive an FM stereo broadcast, make sure that "MONO
is not
displayed. If "MONO
appears, press the FM MODE button to turn the
"MONO
indication off.
"S7 appears when an FM stereo broadcast is received.
If the signal from an FM stereo station is weak and reception is poor,
mess the FM MODE button to change to monaural reception. ("ST" is
2.
Press the MEMORY button.
;eriaced
bv "MONO
in the disdav~)
--
103.25MH
.,
\l/
-1234
H
Changing
the Ml
reception
frequencies
5678
It is not necessary to perform this procedure in the Australia and New
9 10 11 12
13 ,41518
Zealand.
3.
Press the+ or – PRESET button to select the channel number to be
1.
Press the BAND button to select "AM".
preset,
2.
While pressing the MEMORY button on the front panel, press the
9 103.25Mw
button (Deck section) on the front panel.
\l/
=1234
522-1710
kHz (9 kHz steps) —
H
520-1710
kHz (10 kHz steps)
5678
,,
,2
1314
1516
4,
Press the MEMORY button.
In this example,"1 03.25 MHz" FM station is preset on FM channel
number 9.
The number buttons on the remote control can be used for preset
the station. In this example, press O, then 9 after the step 2 above.
FM 103.25MH
m
Note:
If the next step is not taken within 10 seconds while performing steps
2-4,
"PROG." disappears
and the preset operation
is cancelled.
Press the MEMORY button to continue.
LISTENING TO VIDEO SOURCES
1.
Select "VIDEO". "VIDEO
appears on the display.
2.
Follow the instructions
supplied with the video equipment.
10

Advertisement

loading

  Related Manuals for Sanyo DC-F450