Listening To The Radio - Sanyo Dc-MS5 Instruction Manual

LISTENING TO THE RADIO
To turn the unit on and listen to the last received station, press the
TUNEWBAND button.
Automatic/Manual tuning
1.
Press the TUNEWBAND button to select FM or AM.
- "TUNER" is selected automatically. 'TUNE" appears on the
display, then ~UNE" is replaced by the tuner mode display.
2. Automatic tUnin9
Press the "+" or "-" TUNE button (more than 0.7 seconds) to tune in
a station. The unit will scan up or down the band and receive the nexl
receivable station. Press the button again to continue.
Manual tuning
Press the "+" or "-" TUNE button briefly (less than 0.7 seconds'$%til
the desired frequency is displayed. Each time the button is pre&d,
the frequency changes in O.O5 MHz steps for FM and 9 kHz steps for
AM.
FM 103.25 wiz
E!/
,234
S670
@ ,0,,,,
!,!., s,
To preset stations
Up to 16 stations in each band (FM and AM) can be preset.
1. Tune in the station to be preset as described in "Automatic/Manual
tuning".
2. Press the MEMORY
button.
+
——
103.25 M*
3. Press the "+" or "-" PRESET button to select the channel number to
be preset.
9103.25
MHz
.-;
4.
5.
Press the MEMORY button.
In this example,"1 03.25 MHz" FM station is preset on FM channel
number 9.
FM 103.25 ~w
Note:
If the next step is not taken within 10 seconds while performing steps
2-4, "PROG." disappears and the preset operation is cancelled.
Press the MEMORY button to continue.
Repeat the steps above to add more preset stations.
When presetting a new station, the previously preset station on the
same channel number of the same band is cleared.
The preset stations will be retained in the memory even if the unit is
turned off.
If the memory contents are lost due to a power failure or other
condition, preset the stations again.
Listening to preset stations
1.
2.
Press t;e TU-NEWBAND button to select FM or AM.
Press the "+" or "-" PRESET button to select the desired channel
number. The selected channel number blinks on the display.
To receive an FM stereo broadcast, make sure that "MONO" is not
displayed. If "MONO" appears, press the ST/MONO button on the
remote control to turn the "MONO" indication off.
"S~ appears when an FM stereo broadcast is received.
If the sional from an FM stereo station is weak and receDtion is ~oor,
press t;e ST/MONO button to change to monaural reception. (%T" is
replaced by
"MONO"
in the display.)
Changing the AM reception frequencies
It is not necessary to perform this procedure in the Australia and New
Zealand.
1. Press the TUNEWBAND button to select "AM".
2. While pressing the MEMORY button on the front panel, press the
H button on the front panel.
522-1710 kHz (9 kHz steps) —
520-1710 kHz (1 O kHz steps)
LISTENING TO VIDEO SOURCES
1. Select "VIDEO". "VIDEO" appears cn the display.
2. Follow the instructions supplied with the video equipment.
r