Using The Remote Control; Precautions; Remote Control Keys (Functions) - Sanyo HT30746 Owner's Manual

Sanyo ht30746: instruction manual

Hide thumbs Also See for HT30746:

Quick and easy setup (2 pages)

Connection manual (3 pages)

Service manual (56 pages)

Table Of Contents

Table of Contents

PRECAUTIONS

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with

a used battery.

Risk of explosion, if battery is replaced by an incorrect type.

Do not expose the Remote Control Unit to moisture or heat.

REMOTE CONTROL KEYS

Input Key—Press to change the input signal source

as follows: Analog RF ¬ Digital RF ¬ Video1 ¬ Video2

¬ Video3 ¬ HDMI ¬ Analog RF.

Number Keys—Two keys must be pressed to select

a direct channel. Example: Press 0 then 6 to select

channel 6.

For Analog Cable channels above 100, press and

hold the 1 key until C1– – appears, then press the

other two numbers.

Info Key—Press to display the Digital and Analog Full

Banner information (press again to remove the

display).

Digital Full Banner display—Contains a two-part

Channel Number (Major and Minor) and Tuner ID. If

available the following is also included: Station ID,

Program Title, V-Chip Program Rating, Audio Info, and

Signal Strength.

Channel

Major

Minor

Tuner ID

Audio Info

Program Title

Analog Full Banner display—Contains the Channel

Number (analog antenna/cable), Tuner ID, Station ID (if

available), Program Title (if available), V-Chip Program

Rating, and Audio Info.

Need help?

Visit our Web site at