Using The Remote Control - Sanyo HT28745 Owner's Manual

PRECAUTIONS
To ensure safe operation, please observe the following precautions:
Replace both batteries at the same time. Do not use a new battery with
a used battery. Risk of explosion, if battery is replaced by an incorrect
type.
Do not expose the Remote Control Unit to moisture, or heat.
REMOTE CONTROL KEYS
Œ
Power Key—Press to turn DTV on or off.

nput Key—Press to change the input signal source
I
as follows: Analog RF ¬ Digital RF ¬ Video1 ¬ Video2
¬Compo2 ¬ Compo3 ¬ Analog RF .
Ž
Number Key—Two keys must be pressed to select a
direct channel. Example: Press 0 then 6 to select
channel 6. For Analog Cable channels above 100,
press and hold the 1 key until C1– – appears.

Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display):
Digital Full Banner display—Contains a two-part
Channel Number (Major and Minor). If available the
following is also included–Station ID, Program Title,
Date/Time (if set), Antenna Signal Strength, Video Res-
olution, V-Chip Program Rating, and Audio Reception.
Virtual Channel
Major Minor
Video
Program
Title Resolution
Analog Full Banner display—Contains Channel
Number (analog antenna/cable), Date / Time (if set),
Station ID (if available), Program Title (if available),
V-Chip Program Rating, and Audio Reception.
Channel No. Station ID
Audio
Program Title
Reception

USING THE REMOTE CONTROL

Station ID
Time/Date
V-Chip
Signal Audio
Program
Strength Reception
Rating
Current Time/Date
V-Chip Program
Rating
Œ

Ž


‘

Recall Key—Select the first channel you want to
watch; then select another channel using the
NUMBER keys. Press RECALL to easily switch
between the channels.
NOTE: The RECALL key cannot toggle between a
Digital channel and an Analog channel. See TUNER
(#7) key description.
‘
Menu key—Press this key to display the on-screen
menu.
’
Tuner Key—Use this key to toggle from one tuning
system to another, digital channels, and analog
channels.
NOTE: The TUNER key is inactive when an external
input is selected (Video 1, Video 2, Compo 2, or
Compo 3).
“
Cursor L (up) M (down) keys—Press these keys to
move the cursor up and down within the menu.
Cursor (left)
move the cursor left and right within the menu.
Need help?
Visit our Web site at
Point towards
DTV
(right) keys—Press these keys to
(Continued on page 12.)
www.sanyoctv.com 1-800-877-5032
or Call
’
“
11