Pro-Form PFEX15914.0 User Manual page 10

6. Attach the Accessory Tray (9) to the Upright (4)
with an M6 x 50mm Screw (42).
7. Untie and discard the wire tie on the Main
Wire (41).
While a second person holds the Console
Bracket (82) near the Upright (4), route the
Main Wire (41) through the notch in the Upright,
through the Upright Bracket (84), and through
the hole in the center of the Console Bracket.
Tip: Avoid pinching the Main Wire (41). Insert
the Upright Bracket (84) into the Upright (4).
Attach the Upright Bracket (84) with two M8 x
50mm Bolts (49) and two M8 Locknuts (102);
start both Bolts, and then tighten them. Make
sure that the Locknuts are in the hexagonal
holes (A).
8. Identify the Right Handlebar (81) and orient it as
shown.
Tip: Avoid pinching the Right Pulse Wire
(8). Attach the Right Handlebar (81) to the right
side of the Console Bracket (82) with three M8
x 13mm Screws (94); start all the Screws, and
then tighten them.
Then, route the Right Pulse Wire (8) in the Right
Handlebar (81) through the Console Bracket (82)
as shown.
Repeat this step to attach the Left
Handlebar (6).
6
9
7
41
Avoid pinching
the Main Wire (41)
8
94
6
Avoid pinching
the wires
10
42
4
82
84
49
4
102 A
7
82
8
81
94