Start / Stop Cleaning And Adjust Cleaning Time; Lift System - Zodiac AlphaIQ RE4600iQ Owner's Manual

Page 2
Page 12
Page 12
Start / Stop Cleaning and Adjust
Cleaning Time
The factory default cleaning mode is SMART
Cycle (Floor, Wall, Waterline).
Cycle calculates a customized cleaning time
optimized for your pool. On the first run of SMART
Cycle, the control box counts up from zero as it
calculates the optimized cleaning time.
On periodic SMART Cycle cleaning, the control
box will count down from the optimized cleaning
time.
To recalculate the SMART Cycle setting, press
and hold the button for 5 seconds.
Use to change cleaning surface setting.
Toggle between:
Waterline Only
*
(45 min)
Quick Clean
(1h 15 min) Floor only
SMART Cycle
(calculates custom cleaning duration)
Floor, Wall, Waterline
Deep Clean
(2h 45 min)
Floor, Walls, Waterline, High Intensity
*Available on RA 6700 iQ only.
With the cleaner submerged in the water,
press to begin operation.
Press again to interrupt and cancel an in-progress
cleaning cycle.
NOTE: The control box automatically goes into standby
mode after 5 minutes and the display screen turns
off. Press any key to exit standby mode and view
remaining cycle time. Cleaner will continue to
function in standby mode.
Press +/- buttons to increase or decrease cleaning
time in 15-minute increments.
- Minimum run time is 30 minutes
- Maximum run time is 3 hours 30 minutes
Zodiac Alpha RA Robotic Pool Cleaners | Owner's Manual
Zodiac Voyager RE Robotic Pool Cleaners
Zodiac Alpha iQ Robotic Pool Cleaner | Owner's Manual

Lift System

The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be
activated at any time during or after a cleaning
cycle.
1.
2.
3.
4.
5.
NOTE: Never lift the cleaner out of the pool by the floating
|
Owner's Manual
Press to begin the automated
procedure.
The screen displays
Lift System is in operation.
NOTE: To stop the procedure at any time, press and
release the button again.
Next, Press and HOLD
cleaner.
Once the cleaner is facing the wall of your
choice for retrieval, release the button.
Cleaner will drive forward and up the wall it
is facing. It will wait at the water line to be
retrieved.
When in reach, remove the cleaner from
the pool using the handle. The cleaner
will quickly expel water to allow for lighter,
easier removal.
cable.
when the
to rotate the