❹ Maintenance; I Cleaning The Filtration Pump Pre-Filter; I Cleaning The "Cyclonic Tm " Leaf Catcher - Zodiac Baracuda MX 6 Instructions For Installation And Use Manual

❹ Maintenance
• The device must be cleaned regularly using clean or slightly soapy water. Do not use any solvents.
• Rinse the device generously using clean water.
• Do not let your device dry in the sun by the pool.

4.1 I Cleaning the filtration pump pre-filter

• Always remove the cleaner form the pool before cleaning or bleeding the filtration system.
• Before cleaning (and before you put the cleaner back into the water), start the filtration pump
for at least 5 minutes before you bleed the circuit.
• For maximum cleaner effectiveness, you must drain the pump's pre-filter regularly.
• Use of the leaf catcher (accessory included or optional depending on the model) is recommended to collect large
debris before it reaches the skimmer and the pre-filter.
4.2 I Cleaning the "Cyclonic
• Stop the filtration pump.
• Keep the leaf catcher under the water and take hold of it by the handle. Using the handle, turn the transparent tank
until it detaches (see image
• Remove the transparent tank from the water and leave the lid and the hoses under the water (see image
• Remove the filter using the top handle (see image
• Remove the debris and rinse the transparent tank in clean water (see image
• Put the filter back in place and immerse the leaf catcher again (see image
• Position the transparent tank correctly on the lid notches then turn it sharply to push the 2 parts in (see image
H0354600.F - EN - 2015-12
" Leaf Catcher
TM
).
).
).
).
).
EN
).
10