Attach The Control Unit To The Caddy; Connect To A Power Source - Zodiac AlphaIQ RE4600iQ Owner's Manual

Page 2
Page 8
Page 8

Attach the Control Unit to the Caddy

1. Align the bottom of the control unit with the
notch at bottom of the control unit hook on
the caddy (Figure 8).
Figure 8. Align Control Unit with Caddy Hook
2. Press control unit onto the caddy hook until
it snaps and locks into position (Figure 9).
Figure 9. Attach the Control Unit onto Caddy
Zodiac Alpha RA Robotic Pool Cleaners | Owner's Manual
Zodiac Voyager RE Robotic Pool Cleaners
Zodiac Alpha iQ Robotic Pool Cleaner | Owner's Manual

Connect to a Power Source

Failure to comply with the following warnings
can increase risk of fire or electrocution
which can result in property damage and
serious injury, including loss of life.
• Keep the control unit at least 3.5 m from the
edge of the pool.
• The cleaner is to be installed in accordance with
the relevant requirements of the South African
wiring rules in accordance with SANS10142-1.
Also refer to the in-stallation instructions relating
to the swimming pool equipment for which the
cleaner will be an integral part. The cleaner is to
be supplied through a Residual Current Device
(RCD) with a rated residual operating current of
30mA.
• Do not use an extension cord to connect the
control unit.
• Do not allow anyone to swim while the cleaner is
in the pool.
• The control unit is water-resistant, not
water-proof. In order to prevent electrocution,
never submerge the control unit or leave
exposed to inclement weather.
1.
2.
Figure 10. Remove Protective Cap and Connect
|
Owner's Manual
WARNING
PREVENT ELECTRICAL SHOCK
Unscrew the protective cap for the floating
cable from the side of the control unit by
turning counter-clockwise.
Grip the notched end of the floating power
cable, insert into the control unit, and turn
clockwise to tighten. (Figure 10.)
Power Cable