Replacing Wear Parts - Zodiac AlphaIQ RE4600iQ Owner's Manual

Zodiac Alpha RA Robotic Pool Cleaners | Owner's Manual
l u a
3. Place the rear wheels on the caddy and
position the cleaner vertically on the caddy
base.
4. Disconnect the cable from the control box.
Replace the protective cap on the control
box.
5. Loosely coil the power cable starting at the
cleaner and moving toward the connection
point at control box. Store the cable by
wrapping it around the hook located on the
front of the caddy.

Replacing Wear Parts

Replacing Brushes
The cleaner is fi tted with PVC brushes with a
''wear'' indicator.
Figure 23. Worn Brush Indicator
To maintain cleaner performance at its best you
need to replace the brushes as soon as one of the
wear indicators is reached (even if the blade wear
is not even). It is recommended that you replace
the brushes when the rubber is worn down to
the top of the wear indicator (or every two years,
whichever comes fi rst).
To replace a worn brush:
1. Lift the cleaner to a vertical position so that
the handle is up (Figure 26).
|
a n M s e r ' w n O r s n e e a C l o l P o
Zodiac Alpha iQ Robotic Pool Cleaner | Owner's Manual
raised groove becomes
partially flattened,
indicating excessive
wear
t i c b o R o E R r g e y a V o a c d i Z o
Figure 24. Cleaner in Upright Position
2. Separate the edges of the brush and undo
the tabs. Remove the worn brushes.
Figure 25. Undo the Tabs of the Brush
3. To install the new brush, position the new
brush on the roller with the cleaning blades
facing away from the roller.
Figure 26. Install the New Brush
1
2
3
2
e g a P
Page 19
Page 19