Section 4. Control Unit; Start / Stop Cleaning; Lift System - Zodiac CX40 Owner's Manual

Section 4. Control Unit

The Control Unit can be used to initiate basic
cleaning features.
*CX50 model only
Starts/Stops cleaning
Selects cleaning mode:
Floor / Walls / Waterline mode
2h 30 min cycle
(default mode)
Floor Only mode
1h 15 min cycle
Drives the cleaner to the pool edge
for retrieval (CX50 only)
4.1

Start / Stop Cleaning

With the cleaner submerged in the water:
• Press to begin the cleaning cycle.
• Press again to stop the cleaning cycle.
• Press to toggle between cleaning modes:
–
Floor/Walls/Waterline (2h 30 min)
Floor Only (1h 15 min)
–
NOTE: The Control Unit goes into standby after 5
minutes and the display turns off. The cleaner
will continue to function in standby mode. Press
any key to exit standby mode.
Page 8
1. When the cleaning cycle is done, remove the
cleaner from the pool using the handle.
Figure 6. Always remove cleaner using the handle
NOTE: Never lift the cleaner out of the pool by the
floating cable.
4.2 Lift System (CX50 only)
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be
activated at any time during or after a cleaning
cycle.
1. Press to begin the automated
procedure to bring the cleaner to the wall.
NOTE: To stop the procedure at any time, press and
release the button again.
2. Next, Press and HOLD
cleaner.
3. Once the cleaner is facing the wall of your
choice for retrieval, release the button.
4. Cleaner will drive forward and up the wall
it is facing. It will wait at the waterline to be
retrieved.
5. When in reach, remove the cleaner from the
pool using the handle.
Zodiac Robotic Cleaner | Owner's Manual
®
to rotate the