Table of Contents
Advertisement
PAR 20 Warm-On-Dim
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Suspect two potential problem areas: the power supply and the LED.
01) Power supply. Check that the unit is plugged into an appropriate power supply.
02) The LED. Return the PAR 20 to your Showtec dealer.
03) If all of the above appears to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not modify the PAR 20, as this may
damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.
Problem
Probable cause(s)
No power to the fixture
One or more
fixtures do not
function at all
Internal fuse blown
Fixture is too hot
No light or LED
cuts out
intermittently
LED damaged
The power supply settings do not
match local AC voltage and
frequency
Ordercode: 43312
Solution
•
Check if power is switched on and
cables are plugged in
•
Return the PAR 20 to your Showtec
dealer
•
Allow the fixture to cool down
•
Clean the fan
•
Make sure air vents in control
panel and the front lens are not
blocked
•
Turn up the air conditioning
•
Disconnect the fixture and return it
to your dealer
•
Disconnect fixture. Check settings
and correct if necessary
8
Advertisement
Table of Contents
