Advertisement
Note:
• Before installing the unit, connect the wiring temporarily and verify that the unit is
operating properly.
• Use only the parts included with the unit to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
• Consult your dealer if the installation requires drilling of holes, or other modifications
to the vehicle.
• Install the unit where it will not interfere with the driver's ability to control the vehicle
or cause injury to a passenger in the event of a sudden stop.
• To ensure optimum performance, do not install the unit at an angle of more than
30 from the horizontal.
DIN FRONT/REAR-MOUNT
This unit can be installed either from the front (by using the mounting sleeve), or from
the rear (by using the threaded mounting holes on the sides of the unit). For details,
refer to the illustrations of the following installation methods.
1
S
N
T N
2
INSTALLATION
T
N
T
S
Installing the unit by using the factory radio
mounting bracket(s).
1. Determine the correct position where
the holes on the mounting bracket and
the side of the unit match.
Mount 2 screws on each side of the unit.
Use the washer head screws (5x7mm)
3
and the holes marked "N" or "T" or the
pan head screws (4x8mm) and the holes
marked "S".
(The holes marked "T" are for Toyota
and the holes marked "N" are for
Nissan.)
2. Factory radio mounting bracket
3. Dashboard or Console
Note: The support strap, outer trim ring
and half-sleeve are not used in the method
B installation.
3
30˚
Advertisement
