YASKAWA CIMR-DC2A0050BAA Quick Start Manual page 35

Table 16 shows the relationship between the combination of conditions and the set value of H1-.
Setting Value
N.O. contact
24
25
26
27
2C
2D
2E
2F
<1> When using an input contact, set whether to detect a fault when the signal opens or closes. (N.O.: External fault when closed, N.C.: External
fault when open)
<2> When using detection of a fault, set whether to always detect faults or to detect them only during operation.

I/O Setup
Note: The default setting functions can be seen in the connection diagram on page 18.

Multi-Function Digital Inputs (H1-)
The function of each digital input can be assigned in the H1- parameters.

Multi-Function Digital Outputs (H2-)
The function of each digital output can be assigned in the H2- parameters. The setting value of these parameters
consist of 3 digits, where the middle and right digit set the function and the left digit sets the output characteristics (0:
Output as selected; 1: Inverse output).

Multi-Function Analog Inputs (H3-)
The function of each analog input can be assigned in the H3- parameters.

Multi-Function Analog Outputs (H4-)
Use the H4- parameters to set up the output value of the analog monitor outputs and to adjust the output signal
levels.

Test Run Checklist
Review the checklist before performing a test run. Check each item that applies.
No.
1 Thoroughly read the manual before performing a test run.
2 Check the wiring.
3 Set the correct power supply voltage.
4 Turn on the power supply to the converter and drive.
5 Correctly sequence the Run commands.
6
The
7
To give Run command and DC bus voltage reference from the digital operator, press
To give Run command and DC bus voltage reference from the control circuit terminals, press the
8
REMOTE. (The LO/RE indicator is lit off while REMOTE is set.)
YASKAWA ELECTRIC TOEP C710656 06E YASKAWA Power Regenerative Converter - D1000 Quick Start Guide
Table 16 Combination of Conditions
Input contact
<1>
N.C. contact
 –
– 
 –
– 
 –
– 
 –
– 
should light after giving a Run command.
7 Operation with the Drive Connected
Detection
<2>
Detect only
Always detect during operation Stop Unit (fault)
 –
 –
– 
– 
 –
 –
– 
– 
Checklist
Operation selection
Continue
operation
(minor fault)
 –
 –
 –
 –
– 
– 
– 
– 
LO
key to set to LOCAL.
RE
LO
to set
RE
35