Table of Contents
Advertisement
Installation Screws
Refer to
Exterior and Mounting Dimensions on page 13
Precautions and Instructions for Installation
Read the following precautions and instructions before installing models 4A0270 to 4A0630.
WARNING! Crush Hazard. Observe the following instructions and precautions. Failure to comply could result in serious injury or death
from falling equipment.
• Only use vertical suspension to temporarily lift the converter during installation to an enclosure panel.
• Do not use vertical suspension to transport the converter.
• Use screws to securely affix the converter front cover, terminal blocks, and other converter components
prior to vertical suspension.
• Do not subject the converter to vibration or impact greater than 1.96 m/s
by the wires.
• Do not attempt to flip the converter over while it is suspended by the wires.
• Do not leave the converter unattended while it is suspended by the wires.
Horizontal Suspension of Models 2A0065 to 2A0130 and 4A0130 to 4A0370
To make a wire hanger or frame for use when lifting the converter with a crane, lay the converter in a horizontal position
and pass a wire through the holes of the four eye bolts.
NOTICE: Damage to Equipment. When lifting the converter, confirm that the spring washer is fully closed. Failure to comply may
deform or damage the converter when lifted.
Figure 3
A – No space between converter and
B – Spring washer: Fully closed
Vertical Suspension of Models 2A0065 to 2A0130 and 4A0130 to 4A0630
Models 2A0065 to 2A0130 and 4A0130 to 4A0370
When vertical suspension of the converter is required in an enclosure panel, the orientation of the eye bolts for these
converter models can be easily changed by turning the eye bolts counterclockwise 90 degrees.
Figure 4
YASKAWA ELECTRIC TOEP C710656 06E YASKAWA Power Regenerative Converter - D1000 Quick Start Guide
B
A
washer
Figure 4 Details of Spring Washers
Figure 5 Adjusting Angle of Eye Bolts
for the sizes of the installation screws.
2
(0.2 G) while it is suspended
D
C
C – Space between converter and
washer
D – Spring washer: Open
2 Mechanical Installation
11
Advertisement
Table of Contents
