15.8
Changing the headlight bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
15.9
Checking the headlight setting
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Turn protection cap
socket counterclockwise all the way and remove it.
–
Pull bulb socket
E00358-10
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) (
–
Insert the protection cap with the bulb socket into the reflector
and turn it clockwise all the way.
Info
Ensure that O-ring
E00359-10
–
Insert the bulb socket of the position light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
ELECTRICAL SYSTEM 15
1
together with the underlying bulb
2
of the position light out of the reflector.
3
.
p. 153)
4
is seated properly.
p. 121)
B
under the first mark.
5 cm (2 in)
A
5 m (16 ft)
p. 120)
p. 120)
away from the
121