SMART Board SB640 Installation And User Manual page 4

Important information
CAUTION
If you need to lean your interactive whiteboard against a
l
wall before you mount it, make sure that it remains in an
upright position, resting on its pen tray brackets, which
are designed to sustain your interactive whiteboard's
weight.
Do not rest your interactive whiteboard on its side or on
l
the top of its frame.
Do not add any extra weight or excessive pressure to a
l
wall-mounted interactive whiteboard or its pen tray.
SMART designed the brackets to support only the weight
of your interactive whiteboard during normal use.
For operating safety and to prevent damage to your
l
interactive whiteboard, connect its USB connector only to
a computer that has a USB compliant interface and that
bears the USB logo. In addition, the USB source
computer must be compliant with CSA/UL/EN 60950 and
bear the CE mark and CSA and/or UL mark(s) for CSA/UL
60950.
If dust or small items prevent pen tray buttons from being
l
pressed or cause constant button contact, remove the
obstructions carefully.
When transporting your SMART Board interactive
l
whiteboard, repack it with as much of the original
packaging as possible. This packaging was designed
with optimal shock and vibration protection.
Do not allow excess glass cleaner to flow into the crack
l
between the lower frame and the writing surface, or into
the pen tray slots.
Other precautions
If you own a SMART product other than a SMART Board 600 or
D600 series interactive whiteboard, refer to the installation
manual for your product for relevant warnings and maintenance
instructions.
To ensure operating safety and to prevent product damage,
observe the following precautions.
Don't set up or use your interactive whiteboard in an area
l
with excessive levels of dust, humidity or smoke.
If your SMART Board interactive whiteboard requires
l
replacement parts, make sure that the service technician
uses replacement parts specified by SMART Technologies
or parts with the same characteristics as the original.
Be aware that security cable locks aren't designed to be a
l
solid protection measure because the lock can be torn out.
However, potential thieves might be reluctant to try to sell a
product with a broken security cable lock hole, which would
readily identify it as a stolen item.
smarttech.com/kb/001414 4